Weber Saint-Gobain - Official website of the company

weberjoint glitter

formerly Carrojoint glitter

weberjoint glitter
weberjoint glitter

Product benefits

  • Grout with metallic effect
  • Premixed ready to use
  • Easy to apply
  • Non-shrink grout
  • Water resistant
  • Joints up to 7 mm wide

Glittering cementitious tile grout with metallic effect

weberjoint glitter is a cement-based pre-mixed non-shrink grout with decorative effect, used for filling tile joints on walls in wet and dry areas. It is water resistant, easy to apply, and can be cleaned easily. It comes in one component and it only needs to be mixed with water. The glittering effect of weberjoint glitter will give a unique aesthetical aspect. Available in 6 colors with silver or gold effect (refer to our color chart)

Product Features

Scope of use

weberjoint glitter is suitable for interior wall applications to fill joints up to 7mm wide between:

  • Ceramics
  • Mosaic
  • Glass mosaic
  • Porcelain tiles.

Characteristics

Composition Cement, mineral charges, hydrophobic agent, synthetic organic polymers and pigments
Fresh density 1.6 kg/liter
Pot Life 1 hr at 20°C
Shelf Life 12 months
Mixing Ratio 1.55 to 1.8 L /2.5 kg bucket (depending on colors)
Yield 2.5 Kg powder will give approx. 2.5 liters of paste

Consumption

C = 0.16 x E x H x [(L + W) / (L x W)]
C: Consumption (kg/m²)
E: Joint Width (mm)
H: Tile Thickness (mm)
L: Tile Length (cm)
W: Tile Width (cm)

Storage

weberjoint glitter can be stored for 12 months in dry conditions, away from extreme temperatures and protected against wind.

 

 

Documentation

Send or download the documentation

You can either send the documentation to an email address, or download it.

Instructions for use

Surface preparation

weberjoint glitter must be applied after a minimum of 24 hours from tiling, allowing the tile adhesive to set. Surfaces to be grouted must be sound and thoroughly cleaned before the application of weberjoint glitter. All traces of oil or grease must be removed. Maximum joint width should not exceed 7 mm.

Product preparation

Mix 2.5kg of weberjoint glitter with 1.55 to 1.8L. of clean cold water using an electric mixer at low speed (<300 rpm). Mix until a uniform lump free paste is obtained. Let the paste rest for 5 minutes and mix again for 1 minute before starting the application.

Product application

Apply weberjoint glitter with a rubber float into the joints leaving no voids by filling all the gaps. After 2 to 4 hours (depending on ambient temperature) from application, remove the excess grout with a damp sponge and finish gently the entire surface with a dry cloth. After 24 hours, apply muriatic acid diluted (1 acid : 9 water) and leave it for 5 minutes. Clean the grouts with water using a damp sponge to have a better shiny effect.

Cleaning

Clean the tools such as drill, rubber trowel and bucket with water. Cured material need to be removed mechanically.

Environmental and Safety

Safety precautions

The product contains cement powders which, when mixed with water, release alkalis that could be harmful to the skin. It is preferable that the application be done in a ventilated area, and to wear protection for hands, eyes and respiratory system and to avoid breathing dust. Splashes on the skin should be washed away by cleaning thoroughly with soap and water. In case of contact with eyes, wash thoroughly with clean water and seek medical attention. If swallowed, do not induce vomiting and seek medical attention. The product is non-flammable.

Disclaimer

While the company guarantees its products against defective materials, the use and application of these products are made without guarantee since the conditions of their application are beyond its control. It is recommended to verify with the company that the product is suitable for the intended use, and that this Data Sheet version is the latest one. The company may modify it without prior notice. Technical characteristics are listed for guidance only. For more information, please contact the company’s office in your location.

Note

The information included on this Technical Data Sheet is the sole property of SODAMCO Holding. The unauthorized disclosure, use, dissemination or copying (either whole or partial) of this data sheet or any information it contains, is prohibited and subject to legal pursuit.
PG.14
Edition:04/14-A

Available packaging

Lebanon2.5 kg
Syria2.5 kg
Jordan2.5 kg
KSA2.5 kg
UAE2.5 kg
Qatar2.5 kg
Kuwait2.5 kg
Oman2.5 kg